Virtual Device Serial0 Will Start Disconnected File

If you have ever fired up a Cisco router in Dynamips , GNS3 , EVE-NG , or Cisco Packet Tracer , you have likely seen the console output slowly crawl by until it halts at a seemingly concerning line: "Virtual device serial0 will start disconnected" For many students, this message triggers an instinct to panic. Is the router broken? Is the image corrupted? Will Serial0/0 ever come up?

Now go build your topology, connect those serial cables, and watch show interface serial0 finally display the glorious words:

A: The message is printed during boot order, before the emulator has fully initialized the virtual PCI bus and links. It may appear briefly and then be overwritten. If the interface comes up/up after boot, ignore it. If it stays down/down , your link is faulty. virtual device serial0 will start disconnected

[[router R1]] image = c7200.bin serial0 = "R2 serial0" This tells Dynamips to create a direct serial cable between the two virtual devices on boot. A common mistake is logging into the router and typing:

The no shutdown command fixes administratively down (interface disabled by software). It does fix hardware down (no cable, no carrier signal). The "virtual device will start disconnected" message is a hardware-level notification. You cannot fix it with IOS commands; you must fix it in the emulator GUI. The Clock Rate Caveat (DCE vs DTE) Even after you connect the virtual cable, you might still face a down/down or up/down status. After fixing the "start disconnected" message, ensure you have a clock rate set on the DCE side. If you have ever fired up a Cisco

In a real Cisco router, Serial interfaces use . If no cable is plugged in, the interface remains "down/down." However, emulators are not real circuits. If an emulator tried to auto-detect every possible connection at boot, it would slow down the entire lab startup process.

[[router R1]] image = c7200.bin serial0 = "disconnected" To this: Will Serial0/0 ever come up

Always read the console boot messages. That "disconnected" line is not a warning; it is a direct status report. Frequently Asked Questions (FAQ) Q: Does this happen on real Cisco hardware? A: No. Real hardware will show "%LINK-3-UPDOWN: Interface Serial0/0, changed state to down" if no cable is plugged in, but it will never announce "virtual device."